中文 English

联系我们

Lift-Card

Location:Home - Products - Lift-Card

Outbound control board

  

 

Features:

1, the installation of the elevator outbound operation panel.

2, after the boarding card must first use, no card were unable to enter the elevator.

3, if the remote device automatically senses the card, you do not need credit card, automatic identification.

4, more card to become card control system.

5, after the device is powered down, no credit card automatically enters the state.

6. Optional add: deductions, limit and other functions.

Parameters:

1. Input voltage: DC12 ~ 24V

2, a single relay input current: <= 80mA

3, no need to manually input port voltage Fire

4, the control board output point: <= 2-way

5, the output point features: relay switch output.

6. Operating temperature: -10 to 60 degrees Celsius, the working environment humidity: RH30% ~ 95% non-condensing

7. Storage temperature: -20 to 70 degrees Celsius

8 credit card operation time: <100ms

9, IC / ID cards are without networking use

10, credit card records stored in history: up to 2000 (with memory storage)

11, the maximum number set Elevator: Unlimited (issuing settings, without setting on the controller)

12, MTBF:> 20000H

13, the average repair time: <0.2H

Bus Mode

Without networking and management center, just outside each call to install a reader antenna is connected via a bus system with the structure of the reader antenna, each outbound boarding card available, fully functional, more floors, cost more low.

Standalone mode

Without networking and management center, just call out a credit card equipment installation, each one loaded, can call the credit card, fully functional, the less floor, the lower the cost.